PWM driving of high-power LED with an arduino - LEDs and Multiplexing - Arduino Forum

I need to drive 2 red and 2 blue high-power LEDs for an application (LED indicated below). First of all, I connected the LEDs directly to the 12V power supply and measured the currents they draw. As you can see, the red one draws about 1.4A. As you can see, the blue one draws about 0.5A. My question is that I want to use MOSFET to drive these LEDs with PWM, I have shared two circuits below which should I use?Why? Circuit-1 Circuit-2

Mosfet not fully open when using pwm signal from arduino - General Electronics - Arduino Forum

PWM Led drivers which source current? - LEDs and Multiplexing - Arduino Forum

tlc5940 with higher current LEDs - Power management forum - Power management - TI E2E support forums

Switching a LED driver circuit [Solved] - General Electronics - Arduino Forum

Connecting High Power LED to Arduino

Arduino PWM for 12V LED Lights - General Electronics - Arduino Forum

Driving RGB leds with the ULN2003A and pwm on the attiny85 [SOLVED] - LEDs and Multiplexing - Arduino Forum

How can I dim 50 high-power LEDs in series with an Arduino? - Electrical Engineering Stack Exchange

PWM driving of high-power LED with an arduino - LEDs and Multiplexing - Arduino Forum

SOLVED LED strip's brightness regulation - LEDs and Multiplexing - Arduino Forum

LED Fading WIth a MOSFET and a Voltage Converter - LEDs and Multiplexing - Arduino Forum

Basic set-up for TPIC6B595 Shift Register with PWM - LEDs and Multiplexing - Arduino Forum

High Power LED PWM done incorrectly - Motors, Mechanics, Power and CNC - Arduino Forum

PWM issue with Arduino Micro/Leonardo - General Electronics - Arduino Forum

LED driver board - Project Guidance - Arduino Forum