No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the

Repair Arduino Nano (no Power on USB) - Instructables

Help with connecting CNC shield - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno 5 axis wiring - Hardware - Arduino Forum

DC motors are not receiving power - Motors, Mechanics, Power and CNC - Arduino Forum

Connecting both DC motor and Servo Motor to Arduino When There is Only One 5V Pin in Arduino Uno - Robotics - Arduino Forum

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno R3: Directly supply regulated 5V to 5V pin? - Electrical Engineering Stack Exchange

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Getting more than 5v from the UNO 5v pin - Motors, Mechanics, Power and CNC - Arduino Forum

I cant drive my dc motor with arduino and L293D IC - Motors, Mechanics, Power and CNC - Arduino Forum